How to Root XXUGBOB6 Android 5.0 Lollipop Official Firmware on Note 3 LTE N9005

Folks, a step by step tutorial to root XXUGBOB6 Android 5.0 Lollipop stock firmware on Galaxy Note 3 LTE SM-N9005 is now presented in front of you. Before XXUGBOB6 Android 5.0, lot of firmwares based on Lollipop were released for Note 3 LTE but none was as stable as this one and keeping this reason in mind, majority of Note 3 LTE users updated their phablets to it.

Root XXUGBOB6 Android 5.0 Lollipop Official Firmware on Note 3 LTE N9005

If you are one of those and now want root access, then its quite simple. Just go through the instructions posted below to achieve root privileges on your Galaxy Note 3 LTE N9005. Alright?

Safety Guidelines

  • First of all ensure that you have Samsung Note 3 USB Drivers installed on your computer.
  • Make a complete backup of all your important data using CWM recovery or TWRP and keep it safe.
  • Enable the USB Debugging Mode on your phone from Settings –> Developer Options –> “Enable USB Debugging”.
  • Your Note 3 LTE N9005 should be unlocked.


Please read each and every step carefully to root your Note 3 LTE N9005 on XXUGBOB6  Android 5.0 Official OTA. cannot be held responsible if you damage your phone because it will be entirely your fault.

Files Required

Steps to Root XXUGBOB6 Android 5.0 Lollipop Official Firmware on Note 3 LTE N9005

Step 1: Download the CF-Auto-Root Package for Note 3 LTE N9005 on Android 5.0 Lollipop Firmware and Odin. When both are downloaded, extract the zip files to desktop.

Step 2: Now Turn Off your Note 3 LTE N9005 and boot it to Download Mode. For that, Turn it On while pressing and holding “Home + Power + Volume” buttons simultaneously.

Step 3: From Odin folder, run the .exe file to launch Odin and connect your Note 3 LTE N9005 (which is in Download Mode) to your computer via USB cable. You will see ID:COM box light will turn blue if your phone is connected. If it isn’t, make sure you have properly install USB drivers on your computer.

Step 4: Now click on “AP” button in Odin and browse for the this file “CF-Auto-Root-hlte-hltexx-smn9005.tar.md5” (Extracted to desktop in Step 1). After that, make sure “Auto Reboot” , “F.Reset Time” and “Re-Partition” are checked.

Step 5: Check everything once again and if satisfied then click on “Start” button in the center at bottom to start the process of installation which will take few minutes. When your phone is booted and homescreen appears, disconnect it from your Computer.

Congratulations! Your Note 3 LTE N9005 is now rooted on XXUGBOB6 Android 5.0 OTA Stock Firmware using CF-Auto-Root.