Manually Update Galaxy Note 4 N910C (5433) to XXU1BOC3 Android 5.0.1 OTA Stock Firmware

Galaxy Note 4 N910C variant which comes with Exynos 5433 processor has received Android 5.0.1 OTA Stock firmware with build number N910CXXU1BOC3 from Samsung in some regions of Europe like Hungary and Poland.

Manually Update Galaxy Note 4 N910C (5433) to XXU1BOC3 Android 5.0.1 OTA Stock Firmware

As usual the update is released over-the-air and will be rolled out in phases to users in supported regions. However if you are eager to try this out on your Galaxy Note 4 N910C, then our detailed tutorial is here to help you out.

Android 5.0.2 Lollipop N910CXXU1BOC3 Firmware Details

Model Name: Galaxy Note 4 N910C

Version: Android 5.0.2

PDA: N910CXXU1BOC3

CSC: N910COXA1BOC3

Date: 13th March, 2015

Safety Guidelines

  • First of all ensure that you have Samsung Galaxy Note 4 USB Drivers installed on your computer.
  • Make a complete backup of all your important data using CWM recovery or TWRP and keep it safe.
  • Enable the USB Debugging Mode on your phone from Settings –> Developer Options –> “Enable USB Debugging”.
  • Your Galaxy Note 4 N910C should be unlocked.

Disclaimer

Please read each and every step carefully to install N910CXXU1BOC3 Android 5.0.1 Lollipop Official OTA Update on your Galaxy Note 4 N910C. AndroidsDNA.com cannot be held responsible if you damage your phone because it will be entirely your fault.

Files Required

Steps to Manually Update Galaxy Note 4 N910C (5433) to XXU1BOC3 Android 5.0.1 OTA Stock Firmware

Step 1: Download the N910CXXU1BOC3 Android 5.0.1 OTA Stock Firmware for your Galaxy Note 4 N910C along with Odin and place both on desktop. Extract both zips.

Step 2: Now Turn Off your Galaxy Note 4 N910C and boot it to Download Mode. For that, Turn it On while pressing and holding “Home + Power + Volume” buttons simultaneously.

Step 3: From Odin folder, run the .exe file to launch Odin and connect your phone (which is in Download Mode) to your computer via USB cable. You will see ID:COM box light will turn blue if your phone is connected. If it isn’t, make sure you have properly install USB drivers on your computer.

Step 4: Now click on “AP” button in Odin and browse for the firmware files you have downloaded. After that, make sure “Auto Reboot” , “F.Reset Time” and “Re-Partition” are checked.

Step 5: Check everything once again and if satisfied then click on “Start” button in the center at bottom to start the process of installation which will take few minutes. Once your Galaxy S6 updated, it will reboot automatically.

Great! You are done with manually updating your Galaxy Note 4 N910C to XXU1BOC3 Android 5.0.1 Lollipop official OTA Stock Firmware.

Leave a Reply

Your email address will not be published. Required fields are marked *