Update Galaxy Note 3 LTE N9005 to XXUGBOB6 Official Android 5.0 Stock Firmware

If this post aroused your attention to update your Galaxy S3 LTE N9005 to XXUGBOB6 Android 5.0 Official Stock Lollipop firmware, then don’t hesitate and proceed without any tension as we have put together the best tutorial for you.

Update Galaxy Note 3 LTE N9005 to XXUGBOB6 Official Android 5.0 Stock Firmware

Samsung rolled out this XXUGBOB6 Android 5.0 Lollipop update for Galaxy Note 3 LTE N9005 in different regions including Poland and other Europe countries however if you didn’t get OTA notification yet, then utilize Odin.

Android 5.0.2 Lollipop N9005XXUGBOB6 Firmware Details

Model Name: Galaxy Note 3 LTE

Version: Android 5.0

PDA: N9005XXUGBOB6

CSC: N9005XEOGBOB6

Date: 25th February, 2015

Safety Guidelines

  • First of all ensure that you have Samsung Galaxy Note 4 USB Drivers installed on your computer.
  • Make a complete backup of all your important data using CWM recovery or TWRP and keep it safe.
  • Enable the USB Debugging Mode on your phone from Settings –> Developer Options –> “Enable USB Debugging”.
  • Your Galaxy Note 3 LTE should be unlocked.

Disclaimer

Please read each and every step carefully to install XXUGBOB6 Android 5.0 Lollipop Official OTA Update on your Galaxy Note 3 LTE. AndroidsDNA.com cannot be held responsible if you damage your phone because it will be entirely your fault.

Files Required

Steps to Update Galaxy Note 3 LTE XXUGBOB6 N9005 to Official Android 5.0 Stock Firmware

Step 1: Download the N9005XXUGBOB6 Android 5.0 OTA Stock Firmware for your Galaxy Note 3 LTE along with Odin and place both on desktop. Extract both zips.

Step 2: Now Turn Off your Galaxy Note 3 LTE and boot it to Download Mode. For that, Turn it On while pressing and holding “Home + Power + Volume” buttons simultaneously.

Step 3: From Odin folder, run the .exe file to launch Odin and connect your phone (which is in Download Mode) to your computer via USB cable. You will see ID:COM box light will turn blue if your phone is connected. If it isn’t, make sure you have properly install USB drivers on your computer.

Step 4: Now click on “AP” button in Odin and browse for the firmware files you have downloaded. After that, make sure “Auto Reboot” , “F.Reset Time” and “Re-Partition” are checked.

Step 5: Check everything once again and if satisfied then click on “Start” button in the center at bottom to start the process of installation which will take few minutes. Once your Galaxy S6 updated, it will reboot automatically.

Great! You’re done with installing official N9005XXUGBOB6 Stock Android 5.0 Lollipop firmware on your Galaxy Note 3 LTE.

Leave a Reply

Your email address will not be published. Required fields are marked *